Members | Sign In
Legacy MOVI User Community Forum (readonly) > MOVI Question & Answers
avatar

MOVI shield connection

posted Jun 09, 2017 12:15:34 by Craig Morgan
I need to utilize my SPI headers on my Arduino Due board, and the shield is preventing me from doing so, is there a way that I can mount the shield onto a breadboard and run wires to it for operation without damaging the shiled, and will I need to wire all pins or just a few such as the GND, IOREF, AREF, and so on?
[Last edited Jun 09, 2017 14:56:51]
page   1
1 reply
avatar
GeraldFriedland said Jun 12, 2017 02:40:09
Sure. You only need to wire GND, IOREF, VIN, and the two serial ports.

This is described in our manual and also in this Instructable (for Rasberry PI):
http://www.instructables.com/id/Untethered-Speech-Dialog-Using-MOVI-With-the-Rasbe/

Hope that helps,
Gerald
Login below to reply: